The eye syrup filling machine is an automatic machine, so the size of the easy-open bottle, the bottle pad and the cap are required to be uniform.

    First, you must first use the rocker to turn the machine to see if it is abnormal, and it is true that you can drive again.

    Second, when adjusting the machine, the tool should be used properly. It is strictly forbidden to use excessive tools or excessive force to remove the parts to avoid damage to the machine or affect the performance of the machine.

    Third, every time the machine is adjusted, be sure to tighten the loose screws. Rotate the machine with the rocker to see if the motion meets the requirements before driving. The machine must be kept clean. It is strictly forbidden to have oil, liquid or glass debris on the machine to avoid damage to the machine. Therefore, it is necessary to remove the liquid or glass debris in time during the production process.

    Fourth, the machine surface should be cleaned once before the shift, and clean lubricants should be added to each activity department. It should be scrubbed once a week, especially in areas that are not easily cleaned during normal use or blown off with compressed air.

    Fifth, after the machine is unpacked, first check whether the random technical data is complete, and whether the machine is damaged during transportation, so as to solve it in time. Install and adjust the feed and discharge components according to the outline drawings in this manual.

    Sixth, add new lubricant to each lubrication point.

    The seventh and final course is to check the operation of the machine. Turn the machine with the rocker to check if the machine is running in the right direction (counterclockwise in the direction of the motor shaft). The machine must be protected from grounding.