The oral liquid filling machine is suitable for small-dose drowning, sugar filling and capping processes in pharmaceutical factories. The whole machine can complete the processing, bottle, quantitative filling, capping, capping and capping processes. The parts in contact are made of 316L stainless steel or PTFE, which has the functions of no bottle filling, frequency control and so on.

   When the moving tooth plate moves the bottle to the position of the filling liquid of the filling liquid, the convex surface of the cam 7 is separated from the swinging plate 6, and the swinging plate 6 is pulled by the tension spring 4 to swing clockwise, and the swinging plate 6 drives the pressure bottle The bolt 2 is moved downward until it contacts the bottle 3. At this time, the wire rolling head 5 swinging plate 6 should be adjusted to contact and the adjusting screw 8 is adjusted so that the ejector pin 1 protrudes about 4 mm, and an empty bottle is pressed at this position. The bottle stopper 2 and the rocking plate 6 continue to move downward due to the action of the tension spring 4, so that the wire rolling head 5 pulls the steel wire to disengage the ejector pin 1 from the ejector pin 9, so that the infusion device cannot be driven to automatically stop the perfusion of the liquid medicine.

   The oral liquid filling machine has reasonable design, simple structure, convenient operation and mechanical non-bottle stop filling device.

   The oral liquid filling machine is an automatic machine, so the size of the bottle, the bottle pad and the cap are required to be uniform. You must first use the rocker to turn the machine to see if it is abnormal, and you can drive it after you know it is normal. When adjusting the machine, the tool should be used properly. It is strictly forbidden to use excessive tools or excessive force to remove parts to avoid damage to the machine or affect the performance of the machine. Whenever the machine is adjusted, one must actually tighten the loose screws, and use the rocker to turn the machine to see if it meets the requirements. Note when adjusting the lock: After adjusting the various departments, you must pay attention to the lock of each nut. When the initial valve is tested, use the easy-pull bottle. The average height must be taken. Irregular easy-pull bottles cannot enter the lock to avoid damage to the parts.