Eye drops filling machine is suitable for pharmaceutical, chemical, food, light industry and other industries to use vacuum negative pressure and self-priming equipment for glass, plastic, metal and other containers. The machine should be used for the diameter of the container to be filled. The inner surface surface lifting stress should be greater than the liquid static pressure. Such as oral liquid plastic bottles. Wind oil bottles, eye drops, cosmetic perfume bottles, battery fluid filling, etc.

   The eyedrop filling machine consists of an important part such as the bottle feeding carousel, the feeding bottle, the equalizing plate, the filling system, the inner plug outer cover oscillator, the screw cap system, the bottle exit track and the electric control. By means of the bisector positioning, the cam drives the needle up and down to move and fill, and the filling operation is completed at one time. Through the turntable and bottle feeding, aliquot positioning filling, shocking plug, manipulator moving inner plug, adding cover, screw cap, complete the bottle opening action, the diameter of the container to be filled should be small, the liquid surface lifting stress in the caliber should be It is larger than the hydrostatic pressure, which means that the liquid will not flow out after the container is inverted. Such as oral liquid plastic bottles. Wind oil bottle, eye drops bottle, cosmetic perfume bottle, battery liquid filling, etc., 20# mechanical oil should be added to the vacuum pump before starting the machine. The oil quantity must be controlled frequently at the position specified by the oil window. The maximum oil quantity should not exceed the oil. Three-quarters of the height specified by the window.

   The utility model has the advantages of simple structure, reliableness and less failure; the cone piston is used, the sealing performance is good, the liquid volume is accurate, and the liquid volume is convenient to adjust; the liquid contacting part is made of stainless steel, and is convenient for loading and unloading, and can be used for aseptic dispensing; The push rod and piston are made of stainless steel, which is corrosion-resistant and wear-resistant; the speed is continuously adjustable and the operation is convenient.

   Eye bottle filling machine cleaning process: liquid can be removed from the cleaning port, rinsed with water, and cleaned with a non-woven cloth. Wash the sterile preparation or 10,000-level area before operation. Finally, rinse with water for injection, rinse three times for 5 minutes each time until there is no residue, and then wash the contact parts with the material with 75% alcohol. Clean traces can enter the filling process, close the venting valve, the inlet valve, open the vacuum pump, adjust the true air conditioning valve to make the vacuum meet the process requirements, step on the pedals to insert the liquid into the liquid bottle under the irrigation, the container is filled The caliber should be small, the liquid surface lifting stress in the caliber should be greater than the hydrostatic pressure, that is to say, the liquid will not flow out after the container is inverted, and the liquid inlet valve is slowly opened. At this time, the liquid level in the filling is increased, and the venting valve is opened at the same time. The liquid level is maintained between the liquid levels specified by the sight glass. When the vacuum gauge pointer is in the 0 state, it is proved that the filling is completed, and the foot collapsed plate is returned, and the liquid bottle can be opened and the liquid bottle can be filled.